Light
- Mist
- 15 sec
- Pause
- 165 sec
THE WATERLESS DIFFUSER
Pure oil. No water. No heat.
Enjoy essential oils as an intermittent fine mist without adding water or applying heat.
3 mist levels
1 / 2 / 4 / 6-hour timer
2,000 mAh battery
USB-C charging
Soft orange ambient light
MIST CONTROL
Choose your intensity
Pausing between mist cycles is normal and does not indicate a malfunction. Choose a 1, 2, 4, or 6-hour timer. The diffuser automatically turns off when the selected time has elapsed.
Medium
- Mist
- 60 sec
- Pause
- 120 sec
Strong
- Mist
- 120 sec
- Pause
- 60 sec
OIL BOTTLE INSTALLATION
How to install the oil bottle
CAUTION · STEP 3
Remove the dropper insert first.
Always remove the dropper insert before attaching the oil bottle to the diffuser nozzle.
PRODUCT SPECIFICATIONS
Product dimensions & specifications
- Charging port
- USB-C
- Normal charging time
- Approximately 3–5 hours
- Operating temperature
- 0–45°C
CHARGING
Power wherever you are
Charge with a 5V USB adapter, computer USB port, or vehicle USB port. The battery indicator remains illuminated when charging is complete.
Use only safety-certified charging adapters and cables.
RECOMMENDED OILS
Choose a light, fluid oil
For best performance, use 100% pure essential oils with a light, fluid consistency. Resin-based and highly viscous oils can reduce output or block the atomizer. Do not use camphor oil.
AMBIENT LIGHT
A soft orange glow
The diffuser features a soft orange ambient light. Use the light control to turn the light on or off as desired.
CARE & SUPPORT
Everything else you need to know
Care and cleaning
Clean the nozzle when changing oils or whenever the mist output becomes weak.
Routine cleaning
- Add approximately 5 mL of 99% ethyl alcohol or ethanol to an empty compatible bottle.
- Install the bottle in the diffuser.
- Operate the diffuser until the alcohol has been used.
Cleaning with the included bottle
- Add approximately 5 mL of 99% ethyl alcohol or ethanol to the included empty 20 mL bottle.
- Gently shake the bottle to rinse its inner surface, then discard the used alcohol safely.
- Add approximately 5 mL of fresh alcohol and install the bottle in the diffuser.
- Operate the diffuser until the alcohol has been used to clean the nozzle pathway.
Clean only in a well-ventilated area away from heat, sparks, and open flames. Allow every component to dry completely before adding oil.
Important safety information
- Always keep the diffuser upright while an oil bottle is installed.
- Do not invert, tilt, or place the diffuser on its side.
- Place the diffuser on a stable and level surface.
- Do not attempt to disassemble or repair the device.
- Keep the diffuser away from children and pets.
- Do not use resin-based or excessively thick oils.
- Keep the diffuser away from heat, open flames, and direct sunlight.
- For quieter operation, place the diffuser at least 3 feet away.
- For extended storage, remove the oil bottle and store the nozzle separately.
- Use the diffuser only within the recommended operating temperature of 0–45°C.
Why won’t the diffuser turn on?
Connect the diffuser to a power source and allow it to charge before trying again. If it still does not turn on, check the charging cable and adapter.
Why is there no mist?
The essential oil may be too thick, or the atomizer may be blocked. Clean the nozzle and atomizer. If the issue continues, replace the atomizer using the supplied replacement part.
Why can I still smell the previous oil?
A small amount of oil may remain inside the nozzle. Clean the nozzle before switching to a different fragrance.